BenQ W7000+ Utilizing the password function, Setting a password, If you forget the password

Utilizing the password function

For security purposes and to help prevent unauthorized use, the projector includes an option for setting up password security. The password can be set through the On-Screen Display (OSD) menu. Once the password is set and this function is selected, the projector is password-protected. Users who do not know the correct password can not use the projector.

You will be inconvenienced if you activate the password functionality and subsequently forget the password. Print out this manual (if necessary) and write the password you used in this manual, and keep the manual in a safe place for later recall.

Setting a password

Once a password has been set and activated, the projector cannot be used unless the correct password is entered every time the projector is started.

1.Press MENU on the projector or remote control and then press /

until the Advanced Setup menu is highlighted.

2.Press to highlight Password and press ENTER. The Password page displays.

3.Highlight Change Password and press ENTER. The Input Password page displays.

4.As the picture indicates, the four arrow keys ( , , , ) respectively represent 4 digits (1, 2, 3, 4). According to the password you desire to set, press the arrow keys on the remote control or projector to enter six digits for the password.

Confirm the new password by re-entering the new password. Once the password is set, the OSD menu returns to the Password page.

IMPORTANT: The digits being input will display as asterisks on-screen. Write your selected password down here in this manual in advance or right after the password is entered so that it is available to you should you ever forget it.

Password: __ __ __ __ __ __

5.Highlight Power On Lock and then press / to select On.

6.Confirm the current password.

7.To leave the OSD menu, press MENU.

Advanced Setup

Lamp Settings

HDMI Settings
Baud Rate	115200
Test Pattern
High Altitude Mode	Off
Password	ENTER
Key Lock	Off
Reset All Settings
ISF
S-Video	Back
Password
Change Password	ENTER
Power On Lock	Off
	Back

Input New Password

Back

If you forget the password

If the password function is activated, you will be asked to enter the six- digit password every time you turn on the projector. If you enter the wrong password, the password error message as pictured to the right displays lasting for three seconds, and the Input Password page follows. You can retry by entering another six-digit password, or if you did not record the password in this manual, and you absolutely do not remember it, you can use the password recall procedure. See "Entering the password recall procedure" on page 24 for details.

If you enter an incorrect password 5 times in succession, the projector will automatically shut down in a short time.

Password Error

Please try again.

Connecting with video equipment 23