5)Remove damaged supply cord set by taking off the 4 electrical connection screws (block L1, N, L2 and Ground screw, see diagram)
6)Insert the new supply cord set in the strain relief and lock it with two strain relief's screws in suitable position.
7)Fix well the ring terminals G, L1, N, L2 of the new supply cord set as shown in diagram with its 4 screws
8)Re‐install the back enclosure panel with 6 screws
9)Slide the appliance back into its proper location
10)Re‐connect the appliance to the electrical power.
ELECTRICAL GROUNDING
This appliance is equipped with a four‐prong plug for your protection against shock hazard and should be plugged directly into a properly grounded receptacle. Do not cut or remove the grounding prong from this plug.
WARNING!
ELECTRICAL SHOCK HAZARD
Disconnect electrical power at the circuit breaker box or fuse box before installing the appliance.
Provide appropriate ground for the appliance.
Use copper conductors only.
Failure to follow these instructions could result
in serious injury or death
CAUTION
Label all wires prior to disconnecting when servicing controls. Wiring errors can cause improper and dangerous operation.
Verify proper operation after servicing
LOCATION OF APPLIANCE PLATES
The data rating plate shows the model and serial number of your range. It is located under the front edge of the range cooktop, and is visible when the oven door is open (see illustration)
A= Rating plate(s) located under front edge of cooktop
B= Wiring / schematic diagram placed on backside panel and on installation booklet
16
