ELECTRICAL CONNECTION
The appliance shall be connected to a single phase electric line rated at 120/208Vac or 120/240Vac and 60Hz frequency.
Electric power rating:
‐120/208Vac: 6700 Watt or 32 A max.
‐120/240Vac: 8500 Watt or 37 A max.
Heating elements (240V)power rating:
LEFT OVEN:
‐Oven bake element = 2100 Watt
‐Oven circular element = 3300 Watt
‐Oven broil element = 3400 Watt
RIGHT OVEN:
‐Upper + broil element = 900+1100 Watt
‐Bottom element = 900 Watt
WORKTOP ELE. GRIDDLE ELEMENT = 1100 Watt
Install a suitable electric power supply receptacle connection type NEMA 14‐50R able to support a load of at least 40 A (per line) according to local code requirements. For four or three wires power supply connection system see diagram below.
Check your local code for which of the options below should be used in grounding the receptacle power supply connections.
OPTION 1 – FOUR Wires connection:
‐Connect the L1 receptacle terminal to the incoming BLACK electrical supply wire (L1‐hot wire)
‐Connect the L2 receptacle terminal to the incoming RED electrical supply wire (L2‐hot wire)
‐Connect the NEUTRAL receptacle terminal to the incoming NEUTRAL (WHITE) electrical supply wire
‐Connect the GROUND receptacle terminal to the incoming GROUND (GREEN) electrical supply wire
OPTION 2 -
‐Connect the L1 receptacle terminal to the incoming BLACK electrical supply wire (L1‐hot wire)
‐Connect the L2 receptacle terminal to the incoming RED electrical supply wire (L2‐hot wire)
‐Connect the NEUTRAL with the GROUND receptacle terminal to the incoming NEUTRAL (WHITE) electrical supply wire
DO NOT USE EXTENSION CORDS WITH THIS APPLIANCE AS IT MAY RESULT IN FIRE, ELECTRIC SHOCK OR OTHER type of
PERSONAL INJURY.
The appliance is equipped at the factory with an electric supply cord set 4 wires type with ring terminals (L1, L2, N, Ground) suitable for range use UL/CSA listed type SRDT/DRT 2x6AWG (L1, L2)+2x8AWG (N, G) rated 300V, 40 or 50A with fused plug type NEMA 14‐50P; cable length 1,5 m.; in case the supply cord set must be replaced, it shall be replaced with an identical set having the same technical specs and following carefully the instructions and diagrams below:
1)Disconnect appliance from electrical power supply receptacle
2)Slide out the appliance from installation place to access to back enclosure panel
3)Remove back enclosure panel by removing the 6 screws as shown below
14
