Beyonwiz FV-L1 manual Service Scan

Quick Setup

2-3. Service Scan

Before you can watch a broadcasted service, you need to scan for services first. The scanned services will be stored in non-volatile memory. Therefore you don’t have to scan for services again unless you delete services stored in memory. If no services stored in memory, the service scan page will be presented automatically.

Antenna DC (+5V) Power: You can supply DC (+5V, max. 100mA) power to the antenna through the antenna cable. Make sure that your antenna is an active type (i.e. the antenna requires external DC power to enhance the sensitivity) before you supply DC power to the antenna.

Scanning Range: Select either of the following options;

FULL - scans all VHF and UHF channels.

PARTIAL - scans only a specific channel or channel range (requires setting start and end channels manually).

Start Channel (for PARTIAL scanning range only): Select the first channel of your required scanning range.

End Channel (for PARTIAL scanning range only): Select the last channel of your required scanning range.

Signal Quality Bar: Two horizontal bars indicate the signal quality of the start and end channels. The leftmost rectangle changes from black to yellow when the tuner locks the signal properly.

DANGER

IF THE ANTENNA IS A PASSIVE TYPE, ENABLING THE DC POWER MAY DAMAGE THE ANTENNA AND THE FV-L1.

27