BIXOLON SRP-F310/312 service manual Remaining Roll Paper Adjustment

SRP-F310/312

6. Adjustments and Maintenance

6-1 Adjustment

6-1-1 Remaining Roll Paper Adjustment

This sensor is set to the step4 position at the factory. If you find that there is not or too enough paper remaining on the roll when the near-end sensor is triggered, you can change the setting to the upper or Lower position as described below.

Note: The factory setting is based on a paper roll core with an outside diameter of 18mm. If you use a paper

roll with a core with an outside diameter of more than 18mm, it is better to change to the upper position(Rotate the tab at front side) as described below.

1.Open the paper roll cover.

2.Rotate the tab at front or rear Position.

Rev. 1.00 - 53 -