BIXOLON SRP-F310/312 service manual Operation, Setting the DIP switches

SRP-F310/312

2-2 Operation

2-2-1 Setting the DIP switches

The DIP switches are located on the bottom of the printer. The DIP switches are used to set the printer to perform various functions. Follow these when changing DIP switches setting:

1.Turn the printer power switch off. Open the Cover .

2. Flip the DIP switches using tweezers or another marrow-ended

tool. Switches are in when up and off when off down in the Figure 2-9.

3.The new setting takes effect when you turn on the printer.

Note: Always change DIP switch settings only when the printer is turned off. Change made with the power on have no effect and then on again.

Figure 2-9 Setting the DIP switches

2-2-2 Setting the DIP switch (RS-232C Serial Interface)

• DIP Switch

SW	Function	ON	OFF	Default
1-1	Auto-Cutter Selection	Disable	Enable	OFF
1-2	Handshaking	XON/XOFF	DTR/DSR	OFF
1-3	Data Length	7bits	8bits	OFF
1-4	Parity Check	Yes	No	OFF
1-5	Parity Selection	EVEN	ODD	OFF
1-6	Baud Rate Selection (bps)	Refer to the following table		OFF
1-7				ON
1-8				OFF

2-2-3 Setting the DIP switch (IEEE1284 Parallel, USB Interface)

• DIP Switch

SW		Function			ON
1-1		Auto-Cutter Selection		Disable
1-2		Reserved		-
~
1-8
• Table – Baud rate (bps) Selection
	Transmission Speed		SW 1-6		SW 1-7
	2400		ON		OFF
	4800		ON		OFF
	9600		OFF		ON
	19200		OFF		OFF
	38400		OFF		ON
	57600		OFF		OFF
	115200		ON		ON

※Auto Cutter Enable / Disable selection

OFF

Enable

-

SW 1-8

OFF

ON

OFF

OFF

ON

ON

ON

Default

OFF

OFF

Default

9600

Dip Switch Set 1

SW 1-1	ON	Auto Cutter Disabled
	OFF	Auto Cutter Enabled
Application	Ignores Auto Cutter error	for continuous printing.

Rev. 1.00 - 9 -