BIXOLON SRP-F310/312 service manual Setting the Memory Switches, MSW1, MSW2

SRP-F310/312

2-2-6 Setting the Memory Switches

This printer has Memory Switch set which is software switches. Memory Switch set has MSW1, MSW2,MSW3, MSW4, MSW5, MSW6, MSW11, MSW12, Customize value.

Memory Switch setting utility can change the Memory Switch set to ON or OFF as shown in the table below (default: all OFF):

Settings of the Memory Switch are stored in the NV memory: therefore, even if the printer is turned off, the settings are maintained.

※Notes: The Memory Switch is available to be changed by three methods:

-Memory Switch setting utility.

-Control from BXL/POS command.

MSW1

	Switch				Function			ON		OFF
	MSW 1-1			Select Print Speed				Refer to following Table
	MSW 1-2
	MSW 1-3
	MSW 1-4~5						--			Fixed to OFF
	MSW 1-6			Select Print Density				Refer to following Table
	MSW 1-7
	MSW 1-8						--			Fixed to OFF
	MSW1-1~MSW1-3
	MSW 1-3	MSW 1-2		MSW 1-1				Print speed		Remark
	OFF	OFF		OFF			Print speed level 4			270 mm/s
	OFF	OFF		ON			Print speed level 3			250 mm/s
	OFF	ON		OFF			Print speed level 2			230 mm/s
	OFF	ON		ON			Print speed level 1			200 mm/s
	MSW1-6~MSW1-7
	MSW 1-7	MSW 1-6				Print density				Remark
	ON		OFF			Density level 3				Dark
	OFF		ON			Density level 2
	OFF		OFF			Density level 1				Light(Default)
	MSW2
	Switch				Function			ON		OFF
1			Specification for Destination					Double byte Country	Single byte Country
2					Reserved		--			Fixed to OFF
3~8				Code Page Selection				Refer to following Table

Rev. 1.00 - 12 -