Optical indication of anti-theft protection

Flashing KeyCard tongue

When the radio has been switched off and the KeyCard removed, the KeyCard tongue can be programmed to flash as a warning to thieves.

The following requirements must be fulfilled for this to function correctly:

The positive power supply line and the permanent +12 V lead must be connected properly, as described in the installation instructions.

In the DSC mode, the LED setting must be switched to “LED ON”.

If necessary, please refer to the section on “Programming with DSC – VARIOUS, KC LED”.

Switching off the flashing light

The flashing light can be switched off by pushing in the KeyCard tongue to lock it. Before inserting the KeyCard, make sure that the KeyCard tongue is in the out position.

If you would like to deactivate the flashing tongue permanently, switch the LED setting to “LED OFF” in the DSC menu.

For further information, read the section on “Programming with DSC – VARIOUS, KC LED”.

Taking care of your KeyCard

In order to ensure that the KeyCard always functions correctly, it is important for the contacts to be free from any foreign particles. Avoid direct skin contact.

If necessary, clean the KeyCard contacts using a cotton swab dipped in alcohol.

13

DEUTSCH

ENGLISH

FRANÇAIS

ITALIANO

NEDERLANDS

SVENSKA

ESPAÑOL

PORTUGUÊS

 

 

 

 

 

 

 

 

Page 13
Image 13
Blaupunkt RDM 127 operating instructions Optical indication of anti-theft protection, Taking care of your KeyCard