Boca Research 2x2, Turbo1x1 manual Section Two Physical Installation, Select

15

Section Two: Physical Installation

The IO Turbo Series adapter is simple and quick to install— even for the novice computer user. Take a few moments to read over the directions before you begin.

1.Remove your system cover, remembering to power down your system first. You may find it necessary to remove other adapter boards or detach cables. If so, make note of where everything goes. Now, select an empty 16-bit expansion slot. Choose either depending on convenience. Remove the screw and the metal plate that covers the external access to the slot you have selected.

Before inserting the card, check the jumper marked J12. Its default setting is software

select.

or

Software select

High- Speed

Normal

For Windows NT systems, the J12 jumper must be set to either Normal or High-speed. Note that if you set the adapter to high-speed mode, make sure Communication Port Settings (bits per second) are set to one-fourth of the actual speed desired (e.g., 9600bps will yield 38400bps). Note: a serial mouse will not work on the serial ports when the board is set to high-speed mode. For additional information on Windows NT installation, refer to Appendix B in this manual.

Physical Installation