Boca Research 2x2, Turbo1x1 manual Section Four Windows 3.x/DOS Configuration, Dos

25

Section Four: Windows 3.x/DOS

Configuration

1.Power up your system as you normally would. If your system boots into Windows, exit to DOS.

2.Insert the driver diskette. Go to the A:\ prompt, type INSTALL and press ENTER.

IF A PLUG AND PLAY SYSTEM IS DETECTED, continue below (for non Plug and play, continue with page 26).

1.A screen is displayed informing you that your Plug and Play system has detected the new I/O Turbo Series board.

2.You may use your own Plug and Play configuration utility, or select “Install the Locate Utility” to determine how your system configured the I/O Turbo Series board.

3.You will be asked to indicate which operating system you have:

•Windows 3.1, 3.11, Windows for Workgroups 3.11

•DOS

Follow all on-screen directions. Files are then copied to your hard drive. If you are running Windows, you are asked if you want to update your WIN.INI file. Select Yes.

You have the option of re-installing and selecting IOSETUP to change settings which were assigned to the new device. This will require a working knowledge of COM/LPT port and IRQ settings and how these resources are assigned in your system.

Driver Installation