30
| SYMPTOM | POSSIBLE REMEDY |
|
|
|
| My system locks up | • The driver might be set to hardware |
| when exiting my | flow control and the external cable may |
| communication | not be wired correctly. Switch to |
| program. | software flow control. If the problem |
|
| stops, then the cable is wired incorrectly, |
|
| not allowing the external device to |
|
| supply the necessary control signals. |
|
| • Make sure that hardware flow control is |
|
| set in your system. |
|
| • Make sure the attached serial device is |
|
| set to hardware flow control. |
|
|
|
| EPP/ECP hard drive/ | • Ensure the device is connected properly. |
| Most EPP devices have two | |
| does not function. | connectors labelled “COMPUTER” and |
|
| “PRINTER”. The first device should be |
|
| connected to the |
|
| “COMPUTER”. The next device(s) |
|
| should be connected to the |
|
| connector labelled “PRINTER” on the |
|
| first device. |
|
| • If a printer is required, it should be |
|
| connected to the |
|
| labelled “PRINTER” on the last device. |
|
| • Ensure that the driver for each device is |
|
| installed and configured correctly. Note: |
|
| the driver for each device is supplied by |
|
| the vendor of that device. |
|
| • Make sure that the ECP printer port has |
|
| an IRQ assigned for EPP mode, or both |
|
| an IRQ and DMA for ECP mode. |
|
|
|
|
|
|
