Deck Surface
The running deck needs to remain free of any loose items that may become trapped between the running belt and the rollers. Avoid dropping liquids on the deck as this may cause the impregnated wax to gum up and collect at the rollers.
Under extreme conditions resulting in heavy wear and tear on the deck surface, it may be necessary to remove the deck and turn it over, or turn it
Please contact your Bodyguard® Dealer for servicing the deck.
Make certain to have the power off before doing any maintenance.
1 - Breaker
2 - ON/OFF switch
3 - Power inlet
Drive motor with connection wires.
1 - Speed sensor cable
2 - Computer power cable
3 - Computer DATA cable
4 - Elevation motor cable
5 - Power AC cable
6 - Motor cable
figure 11 Motor in treadmill for International models
1 3 2
figure 10
Motor in treadmill for American models
6
1
5 | 4 | 3 | 2 |
|
|
6
5
1
4 | 3 | 2 |
Lubricant application
1.Clean the deck surface and the inside part of the belt with a dry piece of fabric. Clean the belt first by using a long piece of fabric across the belt and start the belt so it makes two complete turns. Then, release the tension on the rear roller to be able to clean the deck surface of any debris or remaining wax.
2.Open the lubricant supplied by your dealer. Place the lubricant tube in the middle of the belt at about 15 inches from the hood cover. Step on the treadmill and step down with your feet where the lubricant tube is located under the belt to make sure that most of the lubricant is now spread evenly on the deck surface. DO NOT START THE TREADMILL YET.
3.Remove the LUBE TUBE from under the belt and put the tension back again on the rear roller. Stand where you applied the lubricant and press JUSTGO to start the belt turning at 0.5 MPH (or 0.8 KMH). Let the belt bring you a the back of the treadmill and come back where you were standing. Do this twice so the lubricant will be present on the total surface of the deck. Start the treadmill and make sure the belt alignment is correct. Refer to the owner’s manual if any problem occurs.
BEST ZONE
30