![2.11 Add/Change User - [COMMAND 56]](/images/new-backgrounds/48020/4802037x1.webp)
GV2 Series Control Panels Owner's Manual Supplement
2.11 Add/Change User - [COMMAND 56]
2.11.1 Description
Use this function to add or change a passcode or card without assistance from your security company. Before adding or changing a passcode or card, you must know which user numbers are available, the authority level you want to assign to the new user, and the areas in which the passcode or card are valid.
I have this feature.
I do not have this feature.
2.11.2Using Add User ?
1.Ensure that the display shows idle disarmed text.
2.Press the [COMMAND] key. The display shows SYSTEM COMMAND.
3.Press [5] and [6].
You can also use the function list in place of steps 2 and 3 to start this function.
1. Press the [MENU] key to enter the function list.
2.Press [NEXT] until you reach the ADD/CHNG USER? prompt.
3.Press [ENT].
4.The display shows ENTER USER #. Enter the user number and press [ENT].
5.The display shows USER # (or user text, such as the name of the user, if this feature was programmed into your system by your security company) to allow for confirmation.
Press [ENT] if the correct user number (or user name) appears. Press [ESC] if not.
6.ADD PASSCODE? appears. (If the user number already exists, CHANGE PASSCODE? Appears.) Press [ENT].
7.ENTER NEW CODE appears. Enter the new passcode followed by [ENT]. ENTER AGAIN appears.
8.Enter the new passcode a second time for confirmation. Press [ENT]. The display shows PASSCODE ADDED (or PASSCODE CHANGED if the user number was already in the system).
Bosch Security Systems, Inc. 2/07 | 19 |
