Bosch Appliances HDI7282U manual Clock, Select Functions Menu

	Getting Started
	See the sections on Using the Cooktop, Using the Oven and Using the Warming
	Drawer for detailed instructions.
The Clock
About the Clock	• Always set the clock after installation or after a power failure. Once power
	returns to the oven, the clock defaults to 12:00 am.
	• The time of day is displayed in hours and minutes.
	• The clock time will appear during all oven operations except when the timer
	is running.
	• The oven is preset to a 12 hour clock and indicates AM and PM. To switch to
	a 24 hour clock, see "Select Function” section.
	• If you do not complete the operation of setting the clock, the oven will beep
	periodically as a reminder to set the clock time. Press OFF to stop the beep-
	ing.

Setting the Clock	1. CLOCK will be displayed and the hour dig-
	its will flash. Turn knob to select hour and	12: 00 AM	CLOCK
	AM or PM.

2.Press TIME. CLOCK will still be displayed and the minute digits will flash.

3.Turn knob. Set minutes.

4.Press TIME and the clock is now set.

Note:

If operation is not completed, the oven will beep periodically as a reminder to set clock time. Press OFF.

Changing the Clock	1.	Press TIME. TIMER 1 flashes in display.
	2.	Turn knob to select CLOCK.
	3.	Press TIME and hour digits flash.
	4.	Turn knob to change hours.
	5.	Press TIME again and minute digits flash.
	6.	Turn knob to change minutes.
	7.	Press TIME again and the clock is set.

1TIME

2	Cooking Mode
	Temperature
	Start

The Select Functions Menu

Note:

To cancel the TIME selection when setting the clock, press OFF any- time while in the clock mode.

SELECT FUNCTIONS is the section of the menu where you can set or change the range features listed below.

To access the SELECT FUNCTION menu

1.Press and hold COOKING MODE pad for five (5) seconds. SELECT FUNC- TION is displayed.

2.Turn knob slowly to desired feature. There will be a slight delay before each message (or feature) can be seen in the display. Turn knob slowly and wait approximately one second for display to show next feature.

3.Press START to choose the function.

4.Turn knob to desired setting and press START.

When all settings for the function are complete, SELECT FUNCTION flashes again.

5.Press OFF to exit the Select Functions Menu.

English 17