22 en | Installing the Monitor High Performance LCD Monitors
F.01U.076.723 | 3.0 | 2009.03 Installation Manual Bosch Secur ity Systems, Inc.

4.2.2 Wall Mount Installation

The square mounting holes (100 mm [3.9 in.] centers) are
compatible with the Bosch UMM-LW-20B fixed wall mount or
the UMM-LW-30B swivel/tilt mount.
Figure 4.1 Mounting the Device
4.3 Connecting the Composite Video Signal to the Monitor
There are two (2) BNC connectors located on the rear side
panel of the monitor for composite video input and two (2) BNC
connectors for composite video outputs (see Figure 2.3).
Note: All video inputs are passive loop-through. The impedance
is automatically set to 75 ohm by the input of the signal on the
input connector, while operating in a single connection mode
(see Figure 4.7). If a cable is also connected to the output
connector, the video signal can be passed on to another
monitor connected to it via the passive loop-through function.
Up to three (3) monitors may be connected in this manner (see
Figure 4.8).