106
Insert Effect Parameter Functions
Rev0.10
This effect reduces the noise and hum. Since it suppresses
the noise in synchronization with the envelope of the sound
(the way in which the sound decays over time), it has very
little effect on the sound, and does not harm the natural
character of the sound.
On/Off OFF, ON
This parameter turns the noise suppressor effect on/off.
Threshold 0 – 100
Adjust this parameter as appropriate for the volume of the
noise. If the noise level is high, a higher setting is
appropriate. If the noise level is low, a lower setting is
appropriate. Adjust this value until the decay of the sound
is as natural as possible.
* High settings for the Threshold parameter may result in
there being no sound when you play with your instruments
volume turned down.
Release 0 – 100
Adjusts the time from when the noise suppressor begins to
function until volume reaches “0.”
This adds a note one octave lower, creating a richer sound.
On/Off OFF, ON
This parameter turns the octave effect on/off.
Oct Level 0 – 100
This adjusts the volume of the sound one octave below.
Dir Level 0 – 100
Adjusts the volume of the direct sound.
By adding varied-phase portions to the direct sound, the
phaser effect gives a whooshing, swirling character to the
sound.
* This effect can be used when the MODULATION “Type”
parameter is set to “PHASER.”
On/Off OFF, ON
This parameter turns the phaser effect on/off.
Rate 0 – 100
This sets the rate of the Phaser effect.
Depth 0 – 100
Determines the depth of the Phaser effect.
Manual 0 – 100
Adjusts the center frequency of the phaser effect.
Resonance 0 – 100
Determines the amount of resonance (feedback). Increasing
the value will emphasize the effect, creating a more unusual
sound.
This effect changes the pitch of the original sound (up or
down) within a range of two octaves.
* This effect can be used when the MODULATION “Type”
parameter is set to “PITCH SFT.”
On/Off OFF, ON
This parameter turns the pitch shifter effect on/off.
Type
Selects either manual pitch shifter “MANUAL” or pedal
pitch shifter “PEDAL.”
MANUAL :
This is a simple pitch shifter.
PEDAL :
The effect will function as a pedal pitch shifter. The effect of
the wah pedal can be obtained by operating the Expression
pedal.
For a detailed explanation, see “When Using an Expression
Pedal” (p. 191).
Pitch -24 – DETUNE – +24
Adjusts the amount of pitch shift (the amount of pitch
change) in semitone steps. By selecting “DETUNE,” you can
add a slightly pitch-shifted sound to the input sound,
producing a detune effect.
* This effect can be used when the “P.Shift Type” parameter is
set to “MANUAL.”
D:E 100:0 – 0:100
This adjusts the volume balance of the direct and effect sounds.
Separation -50 – +50
Adjusts the diffusion. The panning of the direct sound and
effect sound can be spread to left and right. This will be
effective when stereo output is used.
* This effect is obtained with stereo recording (using two
tracks).

Noise Suppressor

Octave

Phaser

Pitch Shifter