59

Repeating Playback (Repeat)

Rev0.10
Section 1
Normally, the repeat start and end points are registered at
the exact position where [REPEAT] is pressed. This may
make it difficult for you to set the repeat portion exactly as
you desire.
If this is the case, you can use the quantize function to have
the time [REPEAT] is pressed be adjusted to the timing of
the song. The quantize function allows you to set the timing
in one-measure units.
Perform the procedure given below to use the quantize
function.
1
Confirm that [PAD] is not lit, then press [UTILITY].
2
Press CURSOR [ ] [ ] to move the cursor to
“SYS,” and press [ENTER].
fig.01-150
3
Press CURSOR [ ] [ ] to select “AB Qtz,” and
turn the TIME/VALUE dial to turn the setting on.
When off, the quantize function will not work.
fig.01-160
4
Press [UTILITY] (or press [EXIT] repeatedly) to return
to the Play screen.
* During updating, “Keep power on!” appears in the upper
line of the display, while the lower line shows what is being
processed.

Setting the Repeat Portion

with Accurate Timing Changing the tempo after having made the quantize
function settings in a repeated portion will result in
timing discrepancies between the repeat start and end
points and the beginnings and ends of measures.
• You can set the repeat portion to one measure by
pressing [REPEAT] twice at the same position.
• When the repeat portion is set, you can use the
following functions to edit your recorded track
data.
- “Copying the repeated portion (AB)” (p. 77)
- “Moving the repeated portion (AB)” (p. 80)
- “Erasing the repeated portion (AB)” (p. 83)
Before using these functions, you can use the
quantize function to set the repeat portion with
accurate timing.