9.1.2. Configuration by Menu

Select option 2 from the “Main Menu” menu to display the Bluetooth settings menu shown below left.

You should enter here the Bluetooth Address (BD_ADDR) of the remote (server) device you wish to pair (in our case this is 000A-4F-00082D) followed by ENTER.

This should be in the same format as indicated on the products label (NAP-UAP-LAP, for those of you who know)

Press “Esc” to skip this section

Press C to select the client option. This setting is stored immediately and is not discarded upon a reboot. In fact it requires a re-boot in order to activate it.

Press “Esc” to skip this option

Re-boot (power cycle) your converter. When the Client BL-521 is switched on, it will connect to the Server device you have entered in the menu above, assuming of course that the server device is also powered up. Remember of course that the factory shipped configuration of the converters is “server” so only 1 device needs any modification in this respect

Manual for BL-521 5_3.doc

© Copyright Brainboxes Limited 2004

Page 31 of 41

Page 31
Image 31
Brainboxes RS232 manual Configuration by Menu