Briggs & Stratton 09801-9 Assembly, Unpacking the Generator, Install Wheel Kit, Vibration, Mount

ASSEMBLY

ASSEMBLY

Your generator requires some assembly and is ready for use after it has been properly serviced with the recommended oil and fuel.

If you have any problems with the assembly of your generator, please call the generator helpline at

1-800-743-4115. If calling for assistance, please have the model, revision, and serial number from the data tag available. See “Know Your Generator” for data tag location.

Unpacking the Generator

1.Set palleted carton on a rigid flat surface.

2.Carefully cut bands around shipping carton.

3.Lift carton off generator.

4.Remove all packing material, carton fillers, etc.

5.Remove generator from shipping pallet.

Install Wheel Kit

The wheel kit is designed to greatly improve the portability of your generator.

NOTE: Wheel kit is not intended for over-the-road use. You will need the following tools to install these components:

•7/16" and 13mm wrench

•Socket wrench with a 7/16" and 13mm socket

•Pliers

•Safety glasses

Refer to Figure 1 and install the wheel kit as follows:

1.Tip generator so that engine end is up.

2.Slide axle through both mounting brackets.

3.Slide a wheel spacer on each side of axle.

4.Place a wheel on each side with air valve facing out.

Figure 1 — Install Wheel Kit

		Support Leg
	Hex Nut
Axle		Vibration	Flat Washer
		Mount
Wheel Spacers			Lock Washer
		20mm
		Cap	20mm Cap Screw
	Flat	Screw
Wheel		E-Ring
	Washer
	7