Briggs & Stratton 8 11., 10.

H.Turn off Machine and Hand-Held Wired Remote Controller.

I. Disconnect electronics and stow controllers in bin below Electronic Machine

Controller (Figure 30).

J. Pull locking pin and secure in hole below latch for transport.

K. Release jacks by turning crank. Wind jack up to approximately 3 inches

(76.2 mm) above surface and rotate jack 90 degrees on its mount. Secure

with pin for transport.

L. Connect trailer to tow vehicle (if previously disconnected).

A. Follow Briggs and Stratton Owners Manual for engine maintenance (the engine

oil drain is located beneath the trailer).

B. Inspect tires (LT 225/75R16) for proper wear and always keep inflated to the

specification denoted on the sidewall of the tire.

C.Inspect lighting and replace bulbs as required.

D.Maintain the hydraulic fluid with auto transmission fluid (Mercon/Dexron III) at

least three quarter tank.

E. Replace filters and auto transmission fluid when it turns brown color or after

500 hours of operation (the reservoir drain is located beneath the trailer).

11.

Problem

Drum moving in the wrong direction

while loading and unloading after the

machine was shut down.

Drum is moving faster or slower than

the arms.

Machine will not run after pressing

load button or the load button LED

kept turning off after pushing it.

Load LED is flashing after pressed.

Solution

Move the drum towards engine using

transport drum button or move it

towards the arms using the load drum

button to guide the controller in the

correct direction of the drum.

The drum speed can be adjusted

using ‘+’ or ‘-’button depending on the

drum direction and speed.

Check the Access Doors if they are

closed and Tilt Panels are tilted.

Turn Load Dial completely

counterclockwise (to zero) and press

button again.

10.