5
OUT OF RANGEOUT OF RANGE
• Full DOT approved lighting package with reflective tape
• Front tongue jack, rated for 7,000 lb capacity.
• Target trailer weight 5,500 lb.
• Trailer width of 8' ft.
• Spare tire included.
• Maximum tongue weight 500 lb.
D. HYDRAULIC SPECIFICATIONS
• 16 HP gasoline engine set at 3000 RPM (16 HP diesel engine is an option).
• 8.4 cc or 0.51 cu. in. Sunstrand pump is used to generate up to 6.5 GPM fo
hydraulic fluid.
• System pressure is set at 2500 psi on the apitech valve.
• 12 Gallon fuel tank estimated to last up to 12 hours of operation.
• Hydraulic oil sight gauge is mounted on hydraulic tank to monitor oil level.
• A5 micron high pressure and 10 micron low filter are used to keep the
hydraulic oil clean. Both filters will indicate on the ECB when elements
are plug.
• Apitech valve controlled (ECB controlled) hydraulic ME-24 Ross motor to
drive arms. Motor to have pulse sensor (30 pulses per rev).
• Apitech valve controlled (ECB controlled) 56 inches hydraulic cylinder to
move drum. Drum to have potentiometer mounted to provide signal feedback
on drum location.
• 2500 psi, 6.5 gpm external hydraulic circuit, controlled by Apitech valve
(ECB controlled). Plumbed at rear of trailer with quick connects for
Condux FO Blower.
• Thermostatic control valve is used on the inlet of the cooler to prevent
hydraulic fluid flowing through 7.8 HP cooler when the temperature has yet
to reach 100 C.
E. ELECTRONIC CONTROL SYSTEM SPECIFICATIONS
Contained within a separate set of documents:
• Remote Electronic Control Box Specification: K:\PRODUCT\Product Dev
Projects\1995\95—52 Figure 8 Trailer\Electronic Controls\Electronic
functions.lwp
• Machine Electronic Control Box Specification: K:\PRODUCT\Product Dev
Projects\1995\95—52 Figure 8 Trailer\Electronic Controls\Machine Control
Panel.lwp
F.ELECTRICAL / ELECTRONIC SPECIFICATIONS
• 12 volt DC electrical system.
• Two12 VDC battery.
• A20 ampere attenuettor is used to generate enough power for the
electrical system.
• Throttle, free wheel, strobe lights, work light, blower and controller switches
with fuse are place on the control panel.
• Glow plug is offer for diesel engine.
• Hour meter, emergency switch, hydraulic system pressure, fuel gauge choke
and push start button are also place on the control panel.
• Two strobe and four clearance lights are offered to satisfy the DOT
specification.
Mounts
For remote in/near control panel, also a mount on the Fiber Optic Cable Blower for the
remote.
Controls: throttle, arm disengage, strobe lights, work light, blower and controller
switches with fuses, also the hour meter, emergency stop switch, hydraulic system
pressure, fuel gauge, choke and push start button.
Glow Plug
Charges through main system, and it is isolated by a diode to prevent drawing from this
power supply for the work light, strobe lights, starter, blower, free wheel solenoid and
throttle.
Storage Area
Secured, weather resistant, and shock absorbing for the remote control and 65' (20 m)
of control cable.
Limit Switches
On all openings and tipping gates
Rear Electric Turk
Connector
To power to Fiber Optic Cable Blower
Tongue Weight
Engine
ELECTRICAL / ELECTRONIC SPECIFICATIONS
Electrical System
12 volt DC
System Pressure
3,000 psi (207 bar)
600-650 lb. (272-295 kg)
12 Gallon (45 liters) estimated to last up to 12 hours of operation
Filtration
TRAILER SPECIFICATIONS
Dual axle, rated for 12,000 lb. (5,443 kg) capacity
Electric
Pintle ring hitch for electric brake
Axle
Brakes
Hitch
Full DOT approved lighting package with reflective tape
Rated for 7,000 lb. (3,175 kg) capacity
6,500 lb. (2,948 kg)
8' (2.44 m) wide x 9' 6" (2.90 m) high x 21' 6" (6.55 m) long
Isolated 12 VDC Power
Supply for ECB
Used on inlet of the cooler to prevent hydraulic fluid flowing through 7.8 HP (5.8 kW)
cooler when temperature has yet to reach 100 C.
5 Micron high pressure and 10 micron low pressure filters used to keep hydraulic oil
clean.
Batteries
Two 12 volt VDC Batteries
2,500 psi (172 bar), 6.5 gpm (25 lpm) external hydraulic circuit.
Offered for the diesel engine
Lights
Two strobe and four clearance lights are offered to satisfy the DOT specification. Work
light is offered to operate the machine in the dark.
Dual Safety Chains
HYDRAULIC SPECIFICATIONS
16 HP @ 3170 RPM (12 kW @ 3170 RPM) Briggs & Stratton V-Twin Vanguaard
*16 HP (12 kW) Diesel engine is an option
Plumbed at rear of trailer with quick connects for Condux Fiber Optic Blower.
Lighting
Hydraulic Flowrate
7 gpm (26 lpm)
Hydraulic Fluid Sight
Gauge With
Thermometer
Mounted on hydraulic tank to monitor fluid level and fluid temperature
External Hydraulics
Thermostatic Control
Valve
Control Panel
Fuel Capacity
Front Tongue Jack
Trailer Weight
Trailer Dimension Size
Minimum 10,000 lb (4,536 kg) capacity