6
Safe Operating Practices
Read and understand all procedures and safety instructions before using the Condux
Figure-8 Eliminator Trailer. Observe all safety information on this page and note
specific safety requirements as explained by procedures called out in this manual.
Failure to follow these instructions could result in serious personal injury, property
damage or death.
A.WORK AREA SAFETY
1. Wear personal protective equipment: hard hat, safety glasses, safety shoes, and
leather work gloves.
2. The safe operation of this equipment requires that the operators be on stable
footing.
3. Stay clear of cables or lines under tension.
4. Do not place cable spool too close to unit. Place the spool far enough away
from the unit to ensure proper control.
5. Do not tamper with relief valves or pressure reducing valves.
B. HYDRAULIC DEVICES
Escaping fluids under pressure can penetrate the skin and cause serious personal
injury. Observe the following precautions to avoid hydraulic hazards:
1. Tighten all connections before applying pressure. Relieve pressure when
connecting or disconnecting hoses when servicing the unit.
2. Check for leaks with a piece of cardboard. Do not use your hands!
3. Do not exceed working pressure of hydraulic hoses.
4. Visually inspect hoses regularly and replace if damaged.
C. ELECTRIC DEVICES
The Hand-Held Wired Remote Controller is an electrical device. Electric shock
hazards exist that could result in severe personal injury or death. Observe the
following precautions to avoid electrical hazards:
1. Do not operate in or near water. This includes setting the Hand-Held Wired
Remote Controller on a wet surface or exposing them to rain.
2. Do not remove cover of the Hand-Held Wired Remote Controller or Electronic
Machine Controller. There are no user-serviceable parts inside. Refer servicing
to qualified service personnel.
3. The Hydraulic Power Unit Controls Power Switch and Controller Power Switch
should be in the off position before connecting or disconnecting any cords.
2.