Briggs & Stratton 8 4.

A. HAND-HELD WIRED REMOTE CONTROLLER

Load Dial

•Controls the speed of the rotating arms from 0 rpm to maximum 40 rpm.

Load Drum button

•Moves the drum to the rear of the machine so the cable can be loaded onto

the machine.

• Stop button will stop the drum from moving and stop this function.

• Pressing the Load Drum button while the function is active will have the same

effect as pressing the Stop button.

Transport Drum button

• Moves the drum to the front of the machine for transport.

• Stop button will stop the drum from moving and stop this function.

• Pressing the Transport Drum button while the function is active will have the

same effect as pressing the Stop button.

Start / On button

• Starts the machine so the Load Dial is functional and allows the arms

to rotate.

• Stop button will stop the arms from rotating and stop this function.

• Load Dial must be turned all the way to zero (counterclockwise) in order to acti-

vate the start button. LED will flash if the Load Dial is not all the way to zero.

4 digit 7 segment LED display

• Normally displays the cable diameter in millimeters or the Drum Position.

• Also displays error codes when an error condition is encountered: FL 1-FULL

if the pressure filter is full; FL 2-FULL if the return filter is full; or door-OPEn

when one of the safety gates is open. These error conditions will flash between

the first and second words and will display for 5-10 seconds before going

back to displaying the cable diameter or Drum Position. They will cycle on

approximately every 20-30 seconds.

• An additional error code will be displayed when connected to the Condux FO

Blower and the blower has been stopped by the blower electronics: FOCB-

StOP. This error condition will flash between the first and second words and will

display as long as the trailer has been disabled by the blower. This condition

can be cleared by pressing the Stop button.