Step 7
Figure 1 shows valve stem and bezel with the control knob removed. Take five large stop plates from the component card and place them over the main and side burner valve stems as illustrated (Figure 2). Take the small stop plate from the component card and place it over the rotisserie burner valve stem (Figure 3). Verify the tab and the stamped letter on the stop plates face out. Replace control knobs when finished.
WARNING: We recommend and request that you do not remove the control panel in order to access the valve tips. If you choose to remove the control panel, you must replace the control panel bezels exactly as illustrated in Figure 2. Failure to replace the bezels as illustrated could lead to personal injury and/or property damage.
Step 8
Carefully replace each burner, making sure burner openings slide over valve nozzles. Screw each main burner "foot" down using screwdriver and screws that were set aside in Step 4. Replace cotter pin in side burner “foot” that were set aside in Step 2.
Step 9
Replace warming rack, cooking grills, heat shields and grease tray.
Note: Follow directions in the leak testing section of this manual before using this grill.
Stop Plate
Tab
L
Stop Pin
Figure 1 | Figure 2 |
Tab | Stop Plate |
S | |
| |
| Stop Pin |
| Figure 3 |
Warming Rack
Cooking Grills
Heat Shields
15
