CART ASSEMBLY | 6 |
|
|
1
Tip: To aid in the assembly process , you may be asked to leave certain screws loose until later in the assembly process. Please pay close attention to each step to determine if you should tighten screws at that time.
Caution: Be careful when handling parts, as they may contain sharp edges. Work gloves are recommended to prevent injury.
Insert six
(6). Leave an 1/8" gap beneath the head of the screws as shown by Figure 1.
Attach front assembly (6) to base (7) with two
FIGURE 2
6
15
7
FIGURE 1
1/8"
19
3
6
2
Fasten side assemblies (3,18) to the front assembly (6) by aligning the keyholes on the side panels to the three screws installed by Step 1, on the front panel, then push down.
Attach the side assemblies to the base (7) with two
3
Attach drip pan bracket (17) to the cart with two
FIGURE 3
2
17
16
15
