Quilting Foot
Reduce the foot pressure and turn the dial on the machine lowering the feed dogs for free motion quilting.
Note
If the foot is frequently used, be sure to apply a small amount of oil about once a month to the area indicated by the arrows. (If too much oil is applied, wipe off the excess with a cloth.)
Walking Foot
Note
•Do not press the foot controller all the way down.
Try to keep the sewing speed low (500 r.p.m. or less).
•The fabric may not feed if you sew at high speeds.
•The feed dog for feeding the cloth may not move if the foot pressure on the fabric is too strong. Use the presser foot pressure adjustment dial to achieve the desired results.
•It is not advisable or necessary to use the Pin Feed mode with the walking foot.
1 Insert the forked part of the operation lever while raised in an upright position onto the screw on the right side of the needle bar, as shown and then insert the capscrew.
2 Tighten the screw securely with a screwdriver. Tightening adequately is important as the screw might loosen due to the foot and forked operation lever vibration.
Secure the capscrew 2 with a screwdriver.
Forked part
1ofleveroperation
22