GETTING READY—————————————————————————————————————————————————————————————————————————————————————————————————————

Installing the bobbin

Install the bobbin wound with thread.

CAUTION

Use a bobbin that has been correctly wound, otherwise the needle may break or the thread tension will be incorrect.

The bobbin was designed specifically for this sewing machine. If bobbins from other models are used, the machine will not operate correctly. Use only the included bobbin or bobbins of the same type (part code: SA156, SFB (XA5539-151)).

c

a b

aThis model

bOther model

c11.5 mm (7/16 inch) (actual size)

Before installing the bobbin or replacing the needle, be sure to turn off the sewing machine, otherwise injuries may occur if the start/stop button is accidentally pressed and the machine starts sewing.

aPress (needle position button) once or twice to raise the needle, and then raise the presser foot lever.

bTurn off the sewing machine (set it to “”).

cSlide the latch on the right side of the bobbin

cover to the right, and then remove the bobbin cover.

a b

aBobbin cover

bLatch

dInsert the bobbin with your right hand so that the thread unwinds to the left side, and then pull the thread firmly under the tab with your left hand.

a

aTab

CAUTION

Be sure to hold down the bobbin with your finger and install the bobbin so that the thread unwinds in the correct direction, otherwise the needle may break or the thread tension will be incorrect.

aNeedle position button

18