
dHold the quilting foot in place with your right hand, and then tighten the presser foot holder screw using the enclosed screwdriver in your left hand.
CAUTION
●Be sure to securely tighten the screw with the enclosed screwdriver, otherwise the needle may touch the presser foot, causing it to bend or break.
eSlide the feed dog position switch, located at the rear of the machine on the base, to the position shown below to lower the feed dogs.
a
aFeed dog position switch (as seen from the rear of the machine)
fTurn on the machine.
gWith the pattern selection dial, select stitch or
.
hUse both hands to stretch the fabric taut, and then move the fabric to follow the pattern. Reinforcement stitches are sewn at the beginning and end of stitching.
a
a Pattern | 3 |
• Reverse stitches cannot be sewn when the | |
feed dogs are lowered. |
iAfter sewing is finished, slide the feed dog position switch to its original position to raise the feed dogs.
• The feed dogs are normally left raised.
Memo
●Turn the handwheel to raise the feed dogs.
73