Brother Brother CP-6500 operation manual Slit Cutter Cut the thread with the cutter

——————————————————————————————————————————————————————————————————————————————————————————————————————————————————————

eWhile lightly holding down the bobbin with your right hand as shown, guide the thread through the slit (a and b). Then, pull the thread toward you to cut it with the cutter (c).

•At this time, check that the bobbin easily rotates counterclockwise.

aSlit

bCutter (Cut the thread with the cutter.)

Note

●If the thread is not correctly inserted through the tension-adjusting spring of the bobbin case, it may cause incorrect thread tension (page 41).

fReplace the bobbin cover. Put the left tab in place (see arrow a), and then press lightly on the right side (see arrow b) until the cover clicks into place.

1

Memo

●You can begin sewing immediately without drawing up the bobbin thread. If you want to draw up the bobbin thread before you start to sew, follow to the procedure in “Drawing up the lower thread” (page 27).

1

aTension-adjusting spring

21