Brother Brother CP-6500 operation manual List of symptoms

APPENDIX ——————————————————————————————————————————————————————————————————————————————————————————————————————————

List of symptoms

■Before sewing

Symptom	Possible cause	How to put it right	Reference
		Raise the needle either by turning the
The needle		handwheel toward you
threader can not	You have not moved the needle	(counterclockwise) so that the mark	page 22
be used. (For	holder to its highest position.	on the wheel points up or by pressing
models equipped		(needle position button) once or
with the needle
		twice.
threader lever.)
	The needle is incorrectly installed.	Correctly install the needle.	page 29
The sewing light	The sewing lamp is damaged.	Contact your retailer or the nearest	–
		authorized service center.
does not come
on.	The machine is not turned on.	Turn on the machine.	page 12
	The thread is not passed through the	Correctly pass the thread through the
	bobbin-winding thread guide		page 16
		bobbin-winding thread guide.
	correctly.
Bobbin thread	Bobbin spins slowly. (for models	Move the sewing speed controller to
does not wind	equipped with the sewing speed	the right (so that the speed will be	page 18
neatly on the	controller.)	fast).
bobbin.
	The thread that was pulled out was	Wind the thread that was pulled off
	not wound onto the bobbin correctly.
		round the bobbin five or six times	page 17
	(For models equipped with the fast	clockwise.
	bobbin winding system.)
The thread does		Raise the needle either by turning the
		handwheel toward you
not pass through
	You have not moved the needle	(counterclockwise) so that the mark
the eye of the			page 22
	holder to its highest position.	on the wheel points up or by pressing
needle. (For
models equipped		(needle position button) once or
with the needle		twice.
threader lever.)
	The needle is incorrectly installed.	Correctly install the needle.	page 29
The needle
threader lever
does not lower to	The needle has not been raised to the
the correct		Press the needle position button.	page 22
position. (For	correct position.
models equipped
with the needle
threader lever.)
While winding
the bobbin, the	You have not wound the bobbin	After removing the thread wound
bobbin thread		below the bobbin winder seat, wind	page 14
was wound	thread properly.
		the bobbin correctly.
below the bobbin
winder seat.

90