Brother Brother CP-6500 CLower the presser foot lever, Install the twin needle in the same way

KNOWING YOUR SEWING MACHINE —————————————————————————————————————————————————————————————————————————————————

cLower the presser foot lever.

aPresser foot lever

CAUTION

●Before replacing the needle, place fabric or paper under the presser foot to prevent the needle from falling into the hole in the needle plate.

dHold the needle with your left hand, and then use a disc-shaped screwdriver to turn the needle clamp screw counterclockwise to remove the needle.

Note

●The needle can be removed by simply loosening the needle clamp screw about one turn. (If the needle clamp screw is loosened too much, the needle clamp (which holds the needle) may fall off. Therefore, do not loosen the needle clamp screw too much.)

aDisc-shaped screwdriver

bNeedle clamp screw

•Do not apply strong force when loosening or tightening the needle clamp screw, otherwise certain parts of the sewing machine may be damaged.

eWith the flat side of the needle toward the rear of the machine, insert the needle until it touches the needle stopper.

aNeedle stopper

fWhile holding the needle with your left hand, use the disc-shaped screwdriver to tighten the needle clamp screw by turning it clockwise.

Install the twin needle in the same way.

CAUTION

●Be sure to insert the needle until it touches the needle stopper and securely tighten the needle clamp screw with the disc-shaped screwdriver, otherwise the needle may break or damage may result.

30