Brother DCP-6690CW j, k, l, m

Wireless configuration for Windows® using the Brother installer application (Not available for MFC-5490CN and MFC-5890CN)

jPress Menu, a or b to choose Network and press OK. Press a or b to choose WLAN and then press OK.

Press a or b to choose SES/WPS/AOSS and press OK.

(For Touchscreen models) 4

Press MENU. Press Network. Press WLAN and then pres s SES/WPS/AOSS.

Note

If your wireless access point supports Wi-FiProtected Setup™ (PIN Method) and you want to configure

your machine using the PIN ( Personal Identification Number) Method, see Using the PIN Met hod of Wi-Fi

Protected Setup™ onpage 35.

kThe machine searches for an access point that supports SecureEasySetup™, Wi-FiProtected Setup™

or AOSS™ for 2 minutes.

lPut your access point in the SecureEasySetup™ mode, Wi-FiProtected Setup™ mode or AOSS™

mode, depending on what is supported by your access point. Please refer to the instruction manual that

came with your access point.

mIf the LCD shows Connected, the machine has successfully connected to your router or access point.

You can now use your machine in a wireless network.

If the LCD shows Setting WLAN, Connecting WLAN, then Connection Failed, the machine has

not successfully connected to your router or access point. Try starting from j again. If the same

message is indicated again, reset the machine back to the default factory settings and try again. For

resetting, see Restoring the network settings to factory default onpage 112.

If the LCD shows Setting WLAN, then Connection Failed or Incorrect Mode, session overlap

is detected (see the table below). The machine has detected more than one router or access point on

your network that has the Wi-Fi Protected Setup™ mode or AOSS™ mode enabled. Make sure that only

one router or access point has the Wi-Fi P rotected Setup™ mode or AOSS™ mode ena bled and try

starting from j again.

LCD messages when using the SES/WPS/AOSS control panel menu

LCD shows Connection status Action

Setting WLAN

Searching or accessing the access point, an d

downloading settings from the access point.

—

Connecting SES

Connecting WPS

Connecting AOSS

Connecting to the access point. —

Connected Connection succeeded. —

Connection Failed

Connection failed.

(If this is shown after the LCD shows

Connecting SES, Connecting WPS or

Connecting AOSS.)

1 Try starting j again.

2 If the same message continues,

reset the machine back to the factory

settings and try again.

A session overlap was detected. Check that only one router or access

point has the Wi-Fi Protected Setup™

mode or AOSS™ mode enabled and try

starting from j again.

Incorrect Mode A session overlap was detected.