USER'S GUIDE

3.Select the font with the Font button. See “FONT button” in Chapter 4.

Modular I/O Card

Before installing the NC-2010h Network card, please note the following information.

Before NC-2010h Installation

(USA)

When you install the NC-2010h Ethernet interface card, this printer complies with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules.

Please refer to the NC-2010h User’s Guide for the FCC notice.

(CANADA)

When you install the NC-2010h Ethernet interface card, this printer complies with the limits for a Class A digital apparatus, pursuant to Canadian Interference-Causing Equipment Regulations.

(Europe)

When you install the NC-2010h Ethernet interface card, this printer complies with EN 55022 Class A.

Warning

In a domestic environment, the printer used with an NC-2010h Network card may cause radio interference, in which cause the user may be required to take adequate measures.

This printer has a modular input/output (MIO) interface slot on the rear panel. This slot allows you to install a commercial MIO-compatible sharing/network card.

For more information about MIO cards, consult the dealer where you purchased this printer.

When you install the MIO card, follow these steps:

1. Turn off the printer and unplug the power cord from the wall socket.

✒Note

Be sure to turn off the power to the printer before installing or removing the MIO card.

Be sure to remove the interface cable connector when installing the MIO card.

5-34