Brother HL-2400C I/F=AUTO, I/F=RS-232C, I/F=PARALLEL, I/F=EXTEND I/O, Sel, Set, Set, Set, Mode, Note, ✒Note, Auto interface selection

CHAPTER 4 CONTROL PANEL

Operation Example: Selecting the Parallel Interface

For this session, select the parallel interface manually as follows:

1.Press the Sel button to set the printer off-line.

2.Press the Mode button and then press the Set Button.

When you enter the interface mode, the display first shows the current interface with the asterisk.

3.Press the ▲ or ▼ button until the desired interface appears on the display.

Display Message	Interface Mode
I/F=PARALLEL	Parallel interface
I/F=RS-232C	Serial interface
I/F=EXTEND I/O	Extended I/O interface
I/F=AUTO	Auto interface selection

✒Note

￿The Extended I/O interface is available only when a commercial MIO compatible sharing/network card has been installed.

￿Some models come with the network card pre-installed.

4.Press the Set button to make the displayed selection effective.

An asterisk appears at the end of the display for a short time. Then the printer automatically exits from the setting menu to the interface menu.

5.Press the ▲ or ▼ button until the exit menu appears on the display.

6.Press the Set button.

Then the printer automatically returns to the off-line ready state.

4–17