Wireless Network | Macintosh |
|
|
n Click Next. The settings will be sent to your printer. The Network Configuration page will be printed. The settings will remain unchanged if you click Cancel.
Note
•If you want to manually enter the IP Address settings of your printer, click
Change IP Address and enter the necessary IP Address settings for your network.
•The wireless network setting will be automatically changed to enabled when the wireless settings are sent to your printer.
o Check the printed Network Configuration page.
Choose the status as it is shown for the Wireless Link Status on the Network Configuration page. Click Next.
If your status is “Link OK.”, go to q.
If your status is “Failed to Associate”, go to p.
p Click Finish. Wireless setup failed as it was unable to associate with a wireless network. This is probably due to incorrect security settings. Reset the print server back to its factory default settings (see page 43). Confirm the security settings that you wrote down on page 31 your wireless network and try starting from d on page 34 again.
q Disconnect the network cable between your access point (hub or router) and the printer, and click Next.
Install the printer driver
IMPORTANT
•DO NOT try to cancel any of the screens during this installation.
•If your wireless settings fail, an error message will appear during the installation of the printer driver and the installation will be terminated. If you encounter this failure, reset the print server back to its default
factory setting (see page 43), and please go back to step e on page 34 and setup the wireless connection again.
r The driver installation starts.
Follow the
Note
Please see the User’s Guide on the
36