Wireless Network

Macintosh

 

 

If the LED indicates Connection Error (See LED indications when using the one-push wireless setting mode on page 53), the printer has detected more than 2 access points/routers on your network that have the SecureEasySetup™, the Wi-Fi Protected Setup mode or the AOSS™ mode enabled. Make sure that only one access point/router has the SecureEasySetup™ mode, Wi-Fi Protected Setup mode or the AOSS™ mode enabled and try starting from j on page 39 again.

n Click Next.

o Check the box after you confirm that you have completed the wireless settings, and then click Next.

Install the printer driver

IMPORTANT

•DO NOT try to cancel any of the screens during this installation.

•If your wireless settings fail, an error message will appear during the installation of the printer driver and the installation will be terminated. If you encounter this failure, reset the print server back to its default

factory setting (see page 43), and please go back to step e on page 38 and setup the wireless connection again.

p The driver installation starts.

Follow the on-screen instructions. Then, restart your Macintosh.

Note

Please see the User’s Guide on the CD-ROM to install the PS driver (Brother’s BR-Script Driver).

q The Brother software will search for the Brother printer. During this time the following screen will appear.

r Choose the printer you wish to connect, and then click OK.

Note

•If there is more than one of the same printer model connected on your network, the MAC Address (Ethernet Address) will be displayed after the model name. You can also confirm your IP Address by scrolling to the right.

•You can find your printer’s MAC Address (Ethernet Address) and the IP Address by printing out the Printer Settings Page. See Print the Printer Settings Page on page 43.

s When this screen appears, click OK.

Finish

The installation is now

complete.

40