Wireless Network

Macintosh

 

 

g

h

i

j

Choose Automatic install (Advanced) and click Next.

Confirm the on-screen message and click Next.

Remove the label covering the USB interface connector to press the wireless setup button.

Press the wireless setup button located at the back of the printer for less than 2 seconds as shown in the illustration below. This will put the printer in one-push wireless setting mode. This feature will automatically detect which mode your access point uses for one-push configuration (SecureEasySetup™,

Wi-Fi Protected Setup or AOSS™).

Note

•Use a pointy object such as a ballpoint pen to press the button.

•If you press the button for 3 seconds or more, the printer will change to the PIN Method of the Wi-Fi Protected Setup mode.

k

The printer starts the one-push wireless setting

 

 

 

mode.The printer will search for an access

 

 

 

point that supports SecureEasySetup™,

 

 

 

Wi-Fi Protected Setup or AOSS™ for 2

 

 

l

minutes.

 

 

Put your access point in the

 

 

 

SecureEasySetup™ mode, the Wi-Fi

 

 

 

Protected Setup mode or the AOSS™ mode,

 

 

 

depending on what is supported by your

 

 

 

access point. Please refer to the instruction

 

 

 

manual that came with your access point.

 

 

m Wait until the Status LED of your printer

 

 

 

indicates Connected. The Status LED will

 

 

 

turn on for 5 minutes. (See LED indications

 

 

 

when using the one-push wireless setting

 

 

 

mode on page 53) This indication means the

 

 

 

printer has successfully connected to your

 

 

 

access point/router. You can now use your

 

 

 

printer with your wireless network.

 

 

 

If the LED indicates Connection Fail (See

 

 

 

LED indications when using the one-push

 

 

 

wireless setting mode on page 53), the printer

 

 

 

has not successfully connected to your access

 

 

 

point/router. Try starting from j again. If the

 

 

 

same message is indicated again, reset the

 

 

 

print server back to its factory default settings.

 

 

 

For resetting, see Reset the network settings to

 

 

 

the factory default on page 43.

 

 

 

If the LED indicates No Access Point (See

 

 

 

LED indications when using the one-push

 

 

 

wireless setting mode on page 53), the printer

 

 

 

has not detected a access point/router on your

 

 

 

network. Make sure you place the printer as

 

 

 

 

Windows

 

close to the network access point/router as

 

 

its factory default settings and try again. For

 

 

possible with minimal obstructions, and try

Wireless

®

 

starting from j again. If the same message is

 

 

 

indicated again, reset the print server back to

 

 

 

resetting, see Reset the network settings to the

 

 

 

factory default on page 43.

Network

 

 

Macintosh

 

 

 

 

 

 

39