![](/images/new-backgrounds/1120650/120650151x1.webp)
Functions
Ch. 3 Functions
R12 3456789 A BCDEFK | |||||||||
R |
|
|
|
|
|
|
|
|
|
RG 11/13 |
|
|
|
|
|
|
|
| |
RH NO B. MARGIN |
|
|
|
|
|
|
| ||
L |
|
|
|
|
|
|
|
| Q |
RI M AUTO |
|
|
|
|
|
|
| ||
RJ AUTO | 1.10 | HELSINKI |
| A | AUTO | ||||
Length | Margin | Font | Width | Size |
3Press or until the desired setting is displayed, or use the number keys to type in the desired block margin width.
NOTE
☞To return the function to its default setting (AUTO), press the space bar.
☞To change the setting in 0.1" (1.0 cm) steps, hold down either or , and then release the key when the desired setting is displayed.
☞The block margins are displayed in the cur- rently selected unit of measurement (inches or centimeters). The unit of measurement can be changed with the Setup functions. (Refer to page 80.)
☞To return to the text without changing the for- matting, press (OR hold down and press ).
4Press to apply the setting.
NOTE
To apply several format settings at the same time, continue pressing or to select the function, then pressing or to select the desired setting. Press only after the necessary functions have
been set.
Block Length function (B. LENGTH)
Normally, the length of each text block auto- matically adjusts to fit the length of the entered text. However, with the Block Length function, you can set each text block to a length between 0.25" and 38.84" (0.6 cm and 99.5 cm).
To change the setting for the Block Length function:
1Hold down and press or .
NOTE
This step may be skipped if settings for several for- mat functions are being applied at the same time.
2Press or until B. LENGTH is dis- played. The current setting is shown on the left side of the display.
R123456789 ABCDEFK | ||||||||
R |
|
|
|
|
|
|
|
|
RG 12/13 |
|
|
|
|
|
|
| |
RH NO B. LENGTH |
|
|
|
|
|
| ||
L |
|
|
|
|
|
|
| Q |
RI M AUTO |
|
|
|
|
|
| ||
RJ AUTO | 1.10 | HELSINKI | A | AUTO | ||||
Length | Margin | Font | Width | Size |
3Press or until the desired setting is displayed, or use the number keys to type in the desired block length.
NOTE
☞To return the function to its default setting (AUTO), press the space bar.
☞To change the setting in 0.1" (1.0 cm) steps, hold down either or , and then release the key when the desired setting is displayed.
☞The block length is displayed in the currently selected unit of measurement (inches or centi- meters). The unit of measurement can be changed with the Setup functions. (Refer to page 80.)
☞To return to the text without changing the for- matting, press (OR hold down and press or ).
4Press to apply the setting.
NOTE
To apply several format settings at the same time, continue pressing or to select the function, then pressing or to select the desired setting. Press only after the necessary functions have
been set.
64