Brother PT-97OOPC Baud rate cannot be set using, Printer utilities, Transferred from computer

Problem		Solution
	• Error 99: the computer cannot detect the printer.
	-	Make sure that the printer is turned on.
	-	Make sure that the interface cable is connected correctly.
	-	Make sure that the COM port where the printer is
		connected is the same COM port selected in the Change
The baud rate cannot be set using the		Baud Rate Wizard. (Many computers have more than one
		COM port and COM2 may have been selected in error in
Change Baud Rate Wizard or the Brother
		the Change Baud Rate Wizard.)
printer utilities.
	• Error 1 or Error 5: the serial port of the computer cannot be
		used.
	• When another serial connection device is using the same
		COM port, labels cannot be printed. Change the COM port
		for the serial connection device or connect the printer to a
		COM port that is not being used.
	To reset the printer, press and hold the power button to turn
I want to reset the printer/delete the data	off the printer. Then, hold down the power button for two
	seconds. Continue holding down the power button, and press
transferred from computer.	the Feed/Cut button six times. The printer will then reset. All
	the transferred data from computer will be deleted and reset
	the printer to factory setting.
I want to cancel the current printing job.	Make sure that the printer is on, and then briefly press the
	power button on the front of the printer.
	• The connected device is incompatible with the
		PT-9800PCN.
		If the LED is flashing in red, either the device is
Data cannot be sent from a device plugged		incompatible with the printer or the device consumes too
		much power. In either case, the device cannot be used with
into the USB Direct Interface on the front		the PT-9800PCN.
of the printer, or a connected device	• The buffer of the PT-9800PCN is full.
cannot be used (PT-9800PCN only).		If the LED flashes in red while connected devices are being
		used, the buffer of the PT-9800PCN may have become full.
		Stop the data transmission, wait until the data buffered in
		the PT-9800PCN has been processed, and then unplug the
		device and plug it in again.
• An error occurred during installation.
• Installation cannot be performed with	Visit http://www.brother-usa.com/faqs
the CD-ROM.
• I would like more information about the
Add-ins.	See “Software User’s Guide” (PDF).
• I do not understand how to connect to a
database.

47