To switch the keypad beeps on and off
Whenever you press a button on the handset, you will hear a beep. You can turn this sound on and off. The original setting is ON.
•Press the ➔ button several times until the display shows SET UP.
•Press the ✔ button. Display shows HANDSET.
•Press the ✔ button. Display shows LEVEL.
•Press the ➔ button. Display shows KEYTONES.
•Press the ✔ button. Display shows the current setting ON or OFF.
•Press the ➔ to change the setting. Display shows OFF or ON.
•Press the ✔ button. A beep confirms that the change has been made.
To reset your Synergy 900 base station to its original settings
•Switch off the mains power.
•Press and hold down the PAGE button. Continue to hold down the PAGE button while switching the mains power back on and for a further five seconds until the base station gives a confirmation beep. After another five seconds a second confirmation beep will indicate that the base station reset is complete.
This will reset:
Base station PIN code to 0000.
Dial delay.
Recall mode.
Ringer volume.
Ringer melody.
It will remove:
All handsets registered to the base station. All shared numbers stored in the memory.
Press the ✗ button to reverse one step of the instructions. Or press and hold to revert quickly to standby.
15
