BT 900 manual Using additional handsets

Using additional handsets

Registering an additional Synergy handset with the base station or re-registering a handset

Up to six handsets can be registered and operated from the Synergy 900 base station. The system allows intercom calls between two handsets while a third is making an external call.

Each additional handset you purchase must be registered with the base station.

Before registering a new handset

Remember to charge the batteries for at least 16 hours. When switched on, the handset will display REG . This tells you that the handset is not registered with the base station.

To register a handset

At the base station:

•Press and hold down the blue PAGE button until you hear a beep (after about 10 seconds).

You now have up to 1 minute to register the handset, during which the IN-USElight flashes on the base station.

At the handset:

•Press the ➔ button several times until the display shows SET UP.

•Press the ✔ button. Display shows HANDSET.

•Press the ✔ button. Display shows LEVEL.

•Press the ➔ button several times until the display shows REG.

•Press the ✔ button. Display shows ADD.

•Press the ✔ button. Display shows PLS WAIT then, after a short delay, the Park No. of the base station.

•Press the ✔ button. Display shows PIN ----.

•Enter the four-digit base station code. (Default 0000. Enter this if the base station code has not been changed.) The ----marks disappear one by one.

•Press the ✔ button. You hear a confirmation beep. Display shows LABEL = (which refers to the handset number).

•Press the ✔ button to automatically allocate the next handset number.

•If you are re-registering your only or first handset, enter 1, followed by the ✔ button. You hear a confirmation beep.

Park No. is a unique number given to each individual base station

24