STABILIZATION OPERATION |
|
|
| |
When you press the Power button the first time, the LED lights in |
|
| ||
orange, and the binoculars go to Standby mode. Your Bushnell StableView |
|
| ||
binoculars go through an internal system check and take about five |
|
| ||
seconds to stabilize their performance. |
| Power Button | ||
Then, turn the stabilization lever to the ACTIVE position. The LED turns | ||||
Stabilization Lever | LED | |||
green, indicating that the stabilization feature is active. |
|
| Indicator | |
|
|
| ||
Stabilization Mode Switching |
|
|
| |
|
|
| ||
There are 2 stabilization modes: the regular stabilization | LED | Status |
| |
mode (normal mode), and enhanced stabilization mode (fine | Lit in orange | Standby (stabilization off) | ||
mode).During use in normal mode, you can switch to fine | Lit in green | Stabilization active (normal) | ||
Flashing in orange/green | Fine mode |
| ||
mode. In fine mode, cancellation of rapid vibration is | Lit in red | Batteries should be replaced | ||
improved over normal mode, achieving sharp, hand held | Flashing in red | System problem |
| |
Off | Power Off |
| ||
images. However, as panning (tracking of the target) motion |
|
|
| |
is not counteracted in fine mode, it is recommended that you first locate the |
|
| ||
|
| |||
target in normal mode, then switch to fine mode for observation. |
|
| ||
Mode Operation |
|
|
| |
Use the power button to switch the stabilization modes. |
|
|
| |
During normal mode operation (Power ON; stabilization lever at |
|
| ||
ACTIVE position), hold down the power button briefly then release to |
|
| ||
operate in fine mode. |
|
|
| |
5
