Cabletron Systems 6C105 setup guide Installing the Cable Management Bar

Setting Up the 6C105

3.2.2Installing the Cable Management Bar

To install the cable management bar, proceed as follows:

1.Remove the cable management bar from the shipping box. Ensure that there are four screws inside the bag with the cable management bar.

2.Refer to Figure 3-1. Line up the two holes on each side of the cable management bar with the two holes located underneath the 6C105, near the front of the chassis.

3.Using a Phillips screwdriver securely fasten the 4 screws.

Bottom of Chassis

Screws (4)

Front Panel of Chassis

Cable Management Bar

2016_05

Figure 3-1 Installing the Cable Management Bar

6C105 Overview and Setup Guide 3-3