Setting Up the 6C105
4.Slide the power supply module into the slot labeled PS1 as follows:
a.Hold the module by placing one hand on the handle located on the module front panel and using the other hand to support the body of the module.
b.With the LED at the top of the power supply module, align the circuit card of the power supply module with the slotted paths on the top and bottom of the opening.
Forcing a misaligned module into place can damage the
!module and/or the chassis backplane.
CAUTION
c.With the power supply inserted into the slotted paths, carefully slide the module forward until it is connected to the backplane with the front panel flush with the face of the 6C105. Do not force the module into place. If significant resistance is encountered before the front panel is flush, remove and reinsert the power supply.
d.Secure the power supply to the chassis by using a screwdriver to tighten the two slotted screws on the top and bottom of the power supply. For proper chassis grounding, the screws must be properly tightened.
5.If you are installing a second power supply, remove the blank plate from the second power supply slot (keep the blank plate in the event you need to remove the power supply), and repeat steps 1– 4.
6C105 Overview and Setup Guide |
