Cabletron Systems BRIM-A6 manual Chapter Installation, Unpacking the Brim

CHAPTER 2

INSTALLATION

This chapter contains instructions for unpacking the BRIM, installing APIMs, and installing the BRIM into Cabletron Systems devices that support BRIM technology.

To install the BRIM and APIMs, you need the following tools:

•1 disposable grounding wrist strap (provided with any MIM or hub)

•1 Phillips-head screwdriver.

The BRIM-A6 and the host MIM or hub are sensitive to static

!discharges. Use a grounding strap and observe all static

C AUT IO N precautions during this procedure. Failure to do so could result in damage to the BRIM-A6 or the host MIM or hub.

2.1 UNPACKING THE BRIM

Unpack the BRIM as follows:

1.Remove the shipping box material covering the BRIM.

2.Carefully remove the module from the shipping box. Leave the module in its non-conductive bag until you are ready to install.

3.Attach the disposable grounding strap to your wrist (refer to the instructions on the disposable grounding strap package).

4.After removing the module from its non-conductive bag, visually inspect the device. If you notice any signs of damage, contact Cabletron Systems Technical Support immediately.

BRIM-A6 User’s Guide Page 2-1