BRIM-A6 User’s Guide | Cabletron Systems guide

Chapter 2: Installation

5.Remove the faceplate mounting screws and the BRIM coverplate. See Figure 2-2.

6.Remove the standoff screws. See Figure 2-2.

7.Place the BRIM behind the hub faceplate. See Figure 2-3.

8.Insert the connector pins of the BRIM-A6 into the BRIM connector on the hub.

9.Press down firmly on the back of the BRIM-A6 until the pins slide all the way into the connector holes.

NOTE

Ensure that the standoffs on the hub align with the standoff screw holes on the BRIM.

10. Reinstall the faceplate mounting screws and the standoff screws.

Ensure that the chassis cover is in place before reconnecting the power cord.

11.Reattach the chassis cover to the hub, reconnect the power cord, and reconnect the hub to your network.

12.Refer to Chapter 3 for instructions on configuring the BRIM-A6 using Local Management.

Page 2-6

BRIM-A6 User’s Guide

Image 19

Cabletron Systems manual BRIM-A6 User’s Guide

Contents

BRIM-A6 USER’S Guide BRIM-A6 User’s Guide DOC Notice FCC NoticeVcci Notice Cabletron SYSTEMS, INC. Program License Agreement Exclusion of Warranty and Disclaimer of LiabilityCabletron Software Program License United States Government Restricted Rights Declaration of Conformity Contents Viii BRIM-A6 User’s Guide Chapter Introduction Using this Manual Following conventions are used throughout this document Document Conventions BRIM-A6 Overview BRIM-A6 Features EMC BRIM-A6 SpecificationsRelated Manuals EMI Getting Help Unpacking the Brim Chapter Installation Installing an Apim Installing Apims Installing a Brim in a MIM Installing Brims Removing the Brim Coverplate Installing a Brim in a Hub BRIM-A6 User’s Guide Chapter Local Management Keyboard Conventions Function Local Management Keyboard Conventions ATM Connection Tables Screen Using LIM to Create PVCs ATM Connection Tables Screen Fields Using ATM Connection Tables Screen Commands ATM Connection Tables Screen Commands Deleting PVCs from the Connection Tables Screen Adding PVCs to the Connection Tables Screen BRIM-A6 Setup Screen Using LM to Create Pvcs VPI BRIM-A6 Setup Screen FieldsVCI BRIM-A6 Setup Screen Commands Accessing the BRIM-A6 Add/Delete Entry Screen Using BRIM-A6 Setup Screen Commands BRIM-A6 Add/Delete Entry Screen Fields Adding a PVC BRIM-A6 Add/Delete Entry Screen Commands Modifying a PVC Deleting a PVC BRIM-A6 LEDs Chapter Describes each of the Apim LEDs Apim LEDs APIM-11 Specifications Appendix a Apim SpecificationsAPIM-21 Specifications APIM-29 Specifications APIM-22 Specifications BNC APIM-67 Specifications ATM Basics Appendix B ATM Overview Figure B-1 ATM Cells ATM Cell BRIM-A6 User’s Guide B-3 Virtual Channels and Virtual Paths ATM Network ATM Protocol Permanent and Switched Virtual Channels B-6 BRIM-A6 User’s Guide BRIM-A6 User’s Guide B-7 B-8 BRIM-A6 User’s Guide