APIM-22 Specifications | Cabletron Systems BRIM-A6 specification

Appendix A: APIM Speciﬁcations

A.3 APIM-22 SPECIFICATIONS

Physical Interface:	STS3
Media Type:	Category V Unshielded Twisted
	Pair
Data Rate:	155 Mbps
Connector Type:	RJ45
Typical Link Distance:	100 Meters

The APIM-22 is considered an ATM User Device and therefore has a different signal pin assignment that the ATM Network Equipment as specified by the ATM Forum User-Network Interface (UNI) specification. Figure A-1 shows the pin assignments for the APIM-22.

1 2 3 4 5 6 7 8

STS

LNK

APIM-22

1.	Transmit +	5.	N/A
2.	Transmit -	6.	N/A
3. N/A		7.	Receive +
4. N/A		8.	Receive -
			142912

Figure A-1 APIM-22 Pin Assignments

A.4 APIM-29 SPECIFICATIONS

Physical Interface:	OC3
Media Type:	Single Mode Fiber
Data Rate:	155 Mbps
Connector Type:	SC
Typical Link Distance:	25 Kilometers

Page A-2

BRIM-A6 User’s Guide

Image 37

Cabletron Systems BRIM-A6 manual APIM-22 Specifications, APIM-29 Specifications

Contents

BRIM-A6 USER’S Guide BRIM-A6 User’s Guide DOC Notice FCC NoticeVcci Notice Cabletron SYSTEMS, INC. Program License Agreement Exclusion of Warranty and Disclaimer of LiabilityCabletron Software Program License United States Government Restricted Rights Declaration of Conformity Contents Viii BRIM-A6 User’s Guide Chapter Introduction Using this Manual Following conventions are used throughout this document Document Conventions BRIM-A6 Overview BRIM-A6 Features Related Manuals BRIM-A6 SpecificationsEMI EMC Getting Help Unpacking the Brim Chapter Installation Installing an Apim Installing Apims Installing a Brim in a MIM Installing Brims Removing the Brim Coverplate Installing a Brim in a Hub BRIM-A6 User’s Guide Chapter Local Management Keyboard Conventions Function Local Management Keyboard Conventions ATM Connection Tables Screen Using LIM to Create PVCs ATM Connection Tables Screen Fields Using ATM Connection Tables Screen Commands ATM Connection Tables Screen Commands Deleting PVCs from the Connection Tables Screen Adding PVCs to the Connection Tables Screen BRIM-A6 Setup Screen Using LM to Create Pvcs VPI BRIM-A6 Setup Screen FieldsVCI BRIM-A6 Setup Screen Commands Accessing the BRIM-A6 Add/Delete Entry Screen Using BRIM-A6 Setup Screen Commands BRIM-A6 Add/Delete Entry Screen Fields Adding a PVC BRIM-A6 Add/Delete Entry Screen Commands Modifying a PVC Deleting a PVC BRIM-A6 LEDs Chapter Describes each of the Apim LEDs Apim LEDs APIM-11 Specifications Appendix a Apim SpecificationsAPIM-21 Specifications APIM-29 Specifications APIM-22 Specifications BNC APIM-67 Specifications ATM Basics Appendix B ATM Overview Figure B-1 ATM Cells ATM Cell BRIM-A6 User’s Guide B-3 Virtual Channels and Virtual Paths ATM Network ATM Protocol Permanent and Switched Virtual Channels B-6 BRIM-A6 User’s Guide BRIM-A6 User’s Guide B-7 B-8 BRIM-A6 User’s Guide