APPENDIX B

FEPIM SPECIFICATIONS

This appendix provides specifications for the Fast Ethernet (Port) Interface Modules. Cabletron Systems reserves the right to change these specifications at any time without notice. The DELHE-UA supports the following Fast Ethernet (Port) Interface Modules: the DELTX-UI, the DELFX-UI, and the DELF3-UI.

B.1 DELTX-UI

The DELTX-UI uses an RJ45 connector supporting Category 5

(85 – 111 ohms) Unshielded Twisted Pair (UTP) and Shielded Twisted Pair (STP) cabling.

The slide switch on the DELTX-UI determines the crossover status of the cable pairs. If the switch is on the X side, the pairs are internally crossed over. If the switch is on the = side, the pairs are not internally crossed over. Figure B-1 shows the pinouts for the DELTX-UI with the switch in each position.

Position X (crossed over)

1.RX+ 5. NC

2.RX- 6. TX-

3.TX+ 7. NC

4.NC 8. NC

x

=

10

100

DELTX-UI

Position =

(not crossed over)

1.TX+ 5. NC

2.TX- 6. RX-

3.RX+ 7. NC

4.NC 8. NC

fecrossover

Figure B-1 DELTX-UI Pinouts

DELHE-UA User’s Guide

B-1

Page 45
Image 45
Cabletron Systems DELHE-UA manual Appendix B Fepim Specifications, Deltx-Ui