Cabletron Systems 1800, FRX4000 Conguring BSCI Ports 8-5

Conﬁguring BSCI Ports 8-5

BSC Interactive Conﬁguration

End-to-End ACK

This read-only parameter is set to No, and indicates that management of

acknowledgments will be handled locally at each end, rather than end-to-end

across the network.

Full Duplex

This read-only parameter is set to Yes, and speciÞes full-duplex transmission.

Physical Port Interface

The physical port interface is deÞned by the portÕs connector and cabling type,

and must be conÞgured as follows:

¥ For the FRX4000 and SmartSwitch 1800, port 0 and port 1 are always RS-232;

¥ For the FRX4000, ports 2 and 3 are determined by the attached cables: RS-232,

V.35, RS-449, or X.21;

¥ For the SmartSwitch 1800, ports 2 and 3 are determined by the attached cables:

RS-232, V.35, or RS-449;

¥ For the FRX4000, ports 4-7 are determined by the expansion Line Interface

Card (LIC) and attached I/O cables. Only the valid interfaces will be listed

from the menu button. Possible interfaces are: RS-232, V.35, RS-449, and X.21.

(RS-449, and X.21 interfaces require an RS-422 LIC.)

¥ For the FRX6000, ports 0-7 on each RLP are determined by the Line Interface

Card (LIC) and attached I/O cables. Only the valid interfaces will be listed

from the menu button. Possible interfaces are: RS-232, V.35, RS-449, RS-530 and

X.21. (RS-449, RS-530, and X.21 interfaces require an RS-422 LIC.)

Blocked Flag

This value will cause the port to be enabled (if No) or disabled (if Yes) when the

device is powered up or re-booted.Whichever state is selected, the port will

remain in that state until this value is changed or until an enable or disable action

is performed. The default value for this parameter is No.

Generate Clock

This setting speciÞes whether the port will generate the clock, or timing,

necessary to synchronize trafÞc over the link. If the port is a physical DCE (as

determined by the portÕs I/O cable interface), specify Yes, since the physical DCE

generates clock. If the port is a physical DTE, specify No. The default value for

this parameter is Yes.

Receive Clock from DTE

This parameter is relevant only if Physical Port Interface (see above) is something

other than RS-232, and Generate Clock (see above) is set to Yes. If this parameter

is set to Yes, it allows the clock (timing) signal to be looped back from the DTE

using the Terminal Timing (TT) signal, which can be helpful on high-speed lines.