Cabletron Systems SEHI-32/34, SEHI-22/24 manual Configuring a Redundant Circuit, Repeater Redundancy

Models: SEHI-22/24 SEHI-32/34

1 90
Download 90 pages 61.33 Kb
Page 46
Image 46
Repeater Redundancy

Repeater Redundancy

spmarun r4red <IP address> <community name>

NOTES

The spmarun script invoked first in the above command temporarily sets the environment variables SPMA needs to operate; be sure to use this command any time you launch an application from the command line. The script is automatically invoked when you launch the application from the icon menu or from within the Hub View.

If you wish to change any redundancy settings, be sure to use a community name with at least Read/Write access. If you only wish to view current settings, a community name with Read access will be sufficient.

If there is a hostname mapped to your SEHI’s IP address, you can use <hostname> in place of <IP address> to launch this application. Please note, however, that the hostname is not the same as the device name which can be assigned via Local Management and/or SPMA; you cannot use the device name in place of the IP address.

The main Repeater Redundancy window, Figure 4-1, will appear.

Figure 4-1. The Repeater Redundancy Window

Configuring a Redundant Circuit

To establish or edit a redundant circuit:

1.In the Repeater Redundancy window, click mouse button 1 on the repeater

interface for which you would like to edit or establish a redundant circuit, then

click spmarun r4red <IP address> <community name>. The Channel X Redundancy window, Figure 4-2, will appear.

4-2

Setting Network Circuit Redundancy

Page 46
Image 46
Cabletron Systems SEHI-32/34 Configuring a Redundant Circuit, Repeater Redundancy, spmarun r4red IP address community name